Our modern production techniques enable us to produce complex wire forms in any quantity and finish. We can arrange lead times to meet your requirements and supply parts electro plated, passivated, painted, shot peened and other finishes
Our design team can provide technical advice or a full design service to support you with your needs.
We manufacture compression, tension and torsion springs, wire forms of most shapes, circlips, “R” pins, and any other wire derived component. We specialise in bespoke parts which are either designed by our customers or by us to suit our customers’ requirements.
Compression or Coil Springs
Compression Springs are wound with a pitched helical form usually with closed ends which are normally ground. Compression loads are applied to the ends of the spring in line with the central axis. Read more about the popular compression spring in our blog. |
Tension Springs
Tension Springs are coiled without any open pitch. The coils are close wound and the load is applied to hooks at each end with an extending load. Hooks can be to a wide range of shapes and sizes. |
Torsion Springs
Torsion Springs can be wound with or without pitch. The ends of Torsion Springs are formed with legs or points of anchorage and rotational loads are applied. Torsion Springs can be produced with one or two coiled bodies.
Find out more about the differences in the mode of operation of a torsion spring in comparison to extension and compression springs.
Torsion Springs can be wound with or without pitch. The ends of Torsion Springs are formed with legs or points of anchorage and rotational loads are applied. Torsion Springs can be produced with one or two coiled bodies.
Find out more about the differences in the mode of operation of a torsion spring in comparison to extension and compression springs.